2.
Install the inhibitor switch (A).
note
Lightly tighten the inhibitor switch mounting bolts so that necessary adjustments can be made.
Check that the shift lever is placed in the "N" position
Install the inhibitor switch (A).
Lightly tighten the inhibitor switch mounting bolts so that necessary adjustments can be made.
Install the manual control lever (A).
Lightly tighten the manual control lever nut (B) so that necessary adjustments can be made.
Align the hole (A) in the manual control lever with the "N" position hole (B) of the inhibitor switch and then insert the SST inhibitor switch guide pin (09480-A3800).
Tighten the nut (A) and bolts (B) with the specified torque.
Tightening torque
A : 17.7 ~ 24.5 N.m (1.8 ~ 2.5 kgf.m, 13.0 ~ 18.1 lb-ft)
B : 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Remove the SST (09480-A3800) from the hole.
Connect the inhibitor switch connector (A).
Install the shift cable by tightening nut (B).
Tightening torque :
9.8 ~ 14.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.8 lb-ft)
Install the air cleaner assembly.
(Refer to "Intake and Exhaust system" in EM group.)
Connect the battery negative (-) cable.
