1.
Loosen the mounting screws, then remove the sunvisor (A) and retainer (B).
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Put on gloves to protect your hands.
Loosen the mounting screws, then remove the sunvisor (A) and retainer (B).
Installation is the reverse of removal.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Put on gloves to protect your hands.
Remove the covers (A) and bolts, then remove the assist handle (B).
Installation is the reverse of removal.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Put on gloves to protect your hands.
After loosening the mounting screws, then remove the overhead console assembly (A).
Disconnect the connectors (A).
Installation is the reverse of removal.
Make sure the connectors are plugged in properly.
Put on gloves to protect your hands.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Remove the following items:
Front seat
(Refer to the BD group - "Front Seat")
Rear seat
(Refer to the BD group - "Rear Seat")
Floor front console
(Refer to the BD group - "Console")
Sunvisor
Assist handle
Overhead console
Front pillar trim
(Refer to the BD group - "Interior Trim")
Front door scuff trim & Rear door scuff trim
(Refer to the BD group - "Interior Trim")
Canter pillar lower trim
(Refer to the BD group - "Interior Trim")
Canter pillar upper trim
(Refer to the BD group - "Interior Trim")
Rear pillar trim
(Refer to the BD group - "Interior Trim")
Detach the clips, then remove the roof trim (A).
Installation is the reverse of removal.
Replace any damaged clips.
Make sure the connector is plugged in properly.
