7904047

1.

IG "OFF".

2.

IG "ON".

3.

Connect GDS and select "Diagnostic Trouble Codes(DTCs)" mode.

4.

Using a GDS, Clear DTC.

5.

Select "Diagnostic Trouble Codes(DTCs)" mode again.

6.

Is the measured resistance within specifications ?

▶ Substitute with a known-good cluster and check for proper operation.

If the problem is corrected, replace cluster and then go to "Verification of Vehicle Repair" procedure.

▶ Fault is intermittent caused by poor connection in CAN signal harness and/or HECU's connector. Go to "Verification of Vehicle Repair" procedure.