5.
Repeat the step 4 two or three times. (until there is no bubble in the fluid)
Tightening torque:
6.8 ~ 9.8 N.m (0.7 ~ 1.0 kgf.m, 9.2 ~ 13.3 lb-ft)
Use the specified fluid. Avoid mixing different brands of fluid.
Specified fluid: SAE J1703 (DOT 3 or DOT 4)
After disconnecting a cap from the concentric slave cylinder air bleeder, insert a vinyl hose in the plug.
Loosening the plug screw, press and release the clutch pedal about 10 times.
Using a flare nut wrench, hold the air bleeder body, being careful not to rotate it. Then use a second flare nut wrench on the plug screw to bleed the clutch master cylinder.
Tighten the plug (A) during the clutch pedal pressed. Afterwards, raise the pedal with a hand.
After pressing the clutch pedal 3 times more, loosen the plug (A) and retighten it with the pedal pressed. Raise it again, then.
Repeat the step 4 two or three times. (until there is no bubble in the fluid)
Tightening torque:
6.8 ~ 9.8 N.m (0.7 ~ 1.0 kgf.m, 9.2 ~ 13.3 lb-ft)
Refill the clutch master cylinder with the specified fluid.
Do not clamp the pipe of a concentric slave cylinder.
Be careful not to damage O-rings.
