Remove the ignition key from the vehicle.
Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.
Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts.
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Install the heater duct to the crash pad.
Install the crash pad. (Refer to the Body group- crash pad)
Tighten the passenger airbag mounting bolts.
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Connect the passenger airbag harness connector to the SRS main harness connector.
Reinstall the glove box. (Refer to the Body group- crash pad)
Reconnect the battery negative cable.
After installing the passenger airbag (PAB), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
