Component Inspection
■ DC solenoid valve Inspection
1.

Ignition OFF.

2.

Disconnect ATM solenoid valve connector.

3.

Measure resistance between DC solenoide vale terminal of ATM solenoid valve component and ON/START power.

Specification : 5.1 ± 0.3 Ω( 25℃ )

note
To view Flash content, you need to install the appropriate browser extension
note
To view Flash content, you need to install the appropriate browser extension
4.

Is measured resistance within specification?

▶ Substitute with a known-good TCM and check for proper operation.If the problem is corrected, replace TCM and then go to "Verification of Vehicle Repair" procedure.

▶ Exchange with a known-good DC solenoid valve and then go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика