2.
Disconnect the crankshaft position sensor connector (A).
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Disconnect the crankshaft position sensor connector (A).
Remove the protector (A).
Remove the installation bolt (A), and then remove the crankshaft position sensor.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
Apply the engine oil to the O-ring.
Insert the sensor in the installation hole and be careful not to damage.
Installation is reverse of removal.
Crankshaft position sensor installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Crankshaft position sensor protector installation bolt (M6): 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Crankshaft position sensor protector installation bolt (M8): 18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)
