3.
Remove the front muffler (B) after disconnect the front oxygen sensor connector (A).
Tightening torque:
39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)
Remove the engine cover.
Disconnect the battery negative terminal.
Tightening torque:
Without battery sensor :
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)
With battery sensor :
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
Remove the front muffler (B) after disconnect the front oxygen sensor connector (A).
Tightening torque:
39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)
Remove the exhaust manifold heat protector (A).
Tightening torque :
7.8 ~ 11.8N.m (0.8 ~ 1.2kgf.m, 5.8 ~ 8.7lb-ft)
Remove the driveshaft heat protector (A).
Remove the exhaust manifold stay (A).
Tightening torque :
M8 bolts(B): 18.6 ~ 27.5N.m (1.9 ~ 2.8kgf.m, 13.7 ~ 20.3lb-ft)
M10 bolts(C): 51.9 ~ 57.8.m (5.3 ~ 5.9kgf.m, 38.3 ~ 42.6lb-ft)
Remove the exhaust manifold (A) with the gasket (B).
Tightening torque
49.0 ~ 53.9N.m (5.0 ~ 5.5kgf.m, 36.2 ~ 39.7lb-ft)
When installing, replace with a new gasket.
When installing the intake manifold, tighten the nuts with pre-torque first, and then tighten the nuts with specified torque in the sequence shown.
Installation is reverse order of removal.
