Replacement
Front Seat Belt Replacement
caution
●

When installing the belt, make sure not to damage the pretensioner.

1.

Remove the following items first :

A.

Front seat assembly

(Refer to the BD group - "Front Seat")

B.

Front door scuff trim & rear door scuff trim

(Refer to the BD group - "Interior Trim")

2.

Remove the seat belt lower anchor cover (A).

3.

After loosening the mounting bolt, then remove the seat belt lower anchor (B).

Tightening torque:

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

4.

Remove the center pillar lower trim (A).

5.

After loosening the mounting screws, then remove the center pillar upper trim (A) .

6.

After loosening the mounting bolt, then remove the front seat belt upper anchor (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

7.

After disconnecting the pretensioner connector lock pin, remove the SIS connector (A), loosen the mounting bolts, then remove the pretensioner (B).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

8.

Installation is the reverse of removal.

Height Adjust Replacement
1.

Remove the following items first :

A.

Front seat assembly

(Refer to the BD group - "Front Seat")

B.

Front door scuff trim & Rear door scuff tirm

(Refer to the BD group - "Interior Trim")

C.

Front seat belt lower anchor

D.

Center pillar lower trim

(Refer to the BD group - "Interior Trim")

E.

Center pillar upper trim

(Refer to the BD group - "Interior Trim")

F.

Front seat belt upper anchor

2.

After loosening the bolts, then remove the height adjustor (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5kgf.m, 28.9 ~ 39.8 lb-ft)

3.

Installation is the reverse of removal.

note
●

Replace any damaged clips.

●

Make sure the height adjusts properly.

Front Seat Belt Buckle Replacement
1.

Remove the front seat assembly.

(Refer to the BD group - "Front Seat")

2.

After loosening the mounting bolt, then remove the front seat belt buckle (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

3.

Disconnect the connector mounting clip (A).

4.

Installation is the reverse of removal.

Яндекс.Метрика