1.
Drill out all spotwelds attaching the fender apron inner front panel.
note
When spotwelded portions are not apparent, remove paint with a rotary wire brush.
Drill out all spotwelds attaching the fender apron inner front panel.
When spotwelded portions are not apparent, remove paint with a rotary wire brush.
Remove the fender apron inner front panel.
Prepare all surfaces to be welded.
After removing, apply the welding primer.
Drill 8mm holes along the new fender apron inner front panel flanges for MIG plug welding.
Fit and clamp the new fender apron inner front panel in place.
Measure each measurement point (Refer to the Body Dimensions) and correct the installation position.
MIG plug weld all holes.
Clean and prepare all welds, and remove all residues.
Apply the epoxy primer to the interior of each panel.
Apply an anti-corrosion agent as required (Refer to the Corrosion Protection).
Prepare the exterior surfaces for priming using wax and grease remover.
Apply metal conditioner and water rinse.
Apply conversion coating and water rinse.
Apply the correct seam sealer to all joints carefully (Refer to the Body Sealing Location).
