3.
Check TPMS sensor's ID out of service data items.
Measuring method : Refer to No.1 Measurement
Fig.1) A method of checking a sensor ID with VCI
■ Check TPMS sensor's ID out of service data items
※ In a case that there are any other DTCs except for C1315 at self-diagnosing, first repair the problems related to those DTCs and then see if C1315 happens again.
Connect VCI to Data Link Connector.
IG KEY ON.
Check TPMS sensor's ID out of service data items.
Measuring method : Refer to No.1 Measurement
Fig.1) A method of checking a sensor ID with VCI
Position the GDS TPMS as near as possible to the tire.
(Reading may take 30~60 seconds depending on the sensor's characteristics.)
Check a sensor's ID out of sensor's information.
No.2) A method of checking a sensor ID with TPMS Exciter
Fig.2) Data displayed by TPMS Exciter
Is the Fig.1's sensor ID same with the Fig.2's ?
 | ▶ Fault is intermittent. It has been repaired and TPMS receiver module memory is not cleared yet. ▶ Go to "Verification of vehicle Repair" procedure. |
 | ▶ Check if a sensor ID is normally enrolled or its type is right. If not, register its ID or replace it with a new one. And then go to "Verification of Vehicle Repair" procedure. ▶ Substitute with a known-good Sensor 1 and check for proper operation. ▶ If the problem is corrected, replace Sensor 1 and then go to "Verification of Vehicle Repair" procedure. |
