Component Inspection
■ Pressure control solenoid valve(LP-VFS) Inspection
1.

Ignition off & Engine Off.

2.

Disconnect "ATM solenoid valve connector.

3.

Measure a resistance between "Pressure control solenoid valve(LP-VFS) " terminal and power at ATM solenoid valve connector.

Specification : 5.1 ± 0.3 Ω( 25℃ )

note
To view Flash content, you need to install the appropriate browser extension
note
To view Flash content, you need to install the appropriate browser extension
4.

Is measured resistance within specification?

▶ Substitute with a known-good TCM and check for proper operation.If the problem is corrected, replace TCM and then go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known-good Pressure control solenoid valve(LP-VFS) and then go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика