2.
Remove the select cable snap pin (A) and then remove the select cable (B) from the shift lever pin.
Remove the floor Interior console assembly.
(Refer to "Interior(Console)" in BD group)
Remove the select cable snap pin (A) and then remove the select cable (B) from the shift lever pin.
Remove the clip (A) and then remove the shift cable (B) from the shift lever assembly.
Remove the clip (A) from the shift lever assembly.
Remove the shift lever assembly (B) after removing shift lever assembly installation bolt (A).
Tightening torque:
8.8 ~13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~10.1 lb-ft)
After installing, check to be sure that this part operates as designed at each range of T/M side corresponding to each position of shift lever.
Installation is the reverse of removal.
When installing, set room side shift lever and T/M side lever to "Neutral" position.
When install the select cable, adjust the select cable.
(Refer to "Control Cable adjustment procedure" in this group.)
