3.
Separate the cable from the control shaft after remove the pin (A) and washer (B).
Remove the following items;
Engine cover.
Air cleaner assembly and air duct.
(Refer to "Intake and Exhaust system" in EM group)
Battery and battery tray.
(Refer to "Charging system" in EE group)
Set Shift lever to "N" position.
Separate the cable from the control shaft after remove the pin (A) and washer (B).
Remove the control shaft assembly (A) after loosen the bolts.
Tightening torque:
24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)
Installation is the reverse of removal.
When installing, set control shaft lever to neutral position.
When installing, apply the sealant as shown in the illustration.
Specified sealant : LOCTITE 5060 or Anaerobic adhesives type J (For flange)
After installling, check to be sure that this part operates as designed at each range of T/M side corresponding to each position of shift lever.
