1.
Disconnect the push rod from the clutch pedal by removing the snap pin (A) and washer (B).
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
Disconnect the push rod from the clutch pedal by removing the snap pin (A) and washer (B).
Remove the following items;
Engine cover
Air cleaner assembly and air duct
(Refer to "Engine And Transaxle Assembly" in EM group.)
Battery and battery tray
(Refer to "Charging system" in EE group.)
In case of diesel, remove the fuel filter.
(Refer to "Fuel Delivery System" in FL group.)
Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.
[Gasoline]
[Diesel]
Remove the clutch master cylinder (A) by turning it clockwise.
[Gasoline]
[Diesel]
Installation is in reverse order of removal.
Perform bleeding air procedure in concentric slave cylinder after pouring the brake fluid.
(Refer to "Concentric slave cylinder" in CH group.)
