2.
Remove the select cable snap pin (A) and then remove the select cable (B) from the shift lever pin.
note
When installing, install the snap pin (A) aftter adjust the select cable.
(Refer to " Control Cable adjustment procedure " in this group.)
Remove the floor Interior console assembly.
(Refer to "Interior(Console)" in BD group)
Remove the select cable snap pin (A) and then remove the select cable (B) from the shift lever pin.
When installing, install the snap pin (A) aftter adjust the select cable.
(Refer to " Control Cable adjustment procedure " in this group.)
Remove the clip (A) from the shift lever assembly.
Remove the clip (A) and then remove the shift cable (B) from the shift cable assembly.
Remove the retainer (A) and nuts (B).
Tightening torque:
9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.9 lb-ft)
Remove the SRS Control Module.
(Refer to "SRSCM" in RT group)
Remove the following items;
Air cleaner assembly and air duct.
(Refer to "Engine And Transaxle Assembly" in EM group.)
Battery and battery tray.
(Refer to "Charging system" in EE group.)
Remove the shift & select cable (B).
Remove the pin and washer (A).
Make unlock clip (C) and then remove the shift & select cable (B) and the clip (C) from the bracket.
When intalling, do not reuse the clip (C).
Remove the shift cable at cabin room.
Installation is the reverse of removal.
When installing, set room side Shift lever and T/M side lever to N position.
When installing, adjust the select cable.
(Refer to " Control Cable adjustment procedure " in this group.)
