Connect GDS to Data Link Connector(DLC).

IG "ON"

Perform applicable troubleshooting guide procedure when other than DTC C1663 is stored.

In case only DTC C1663 is stored, clear DTC and then drive vehicle for certain amount of time.Reference)Auto Location

Auto Location

- Auto Location is performed when stop for over 19 minutes or driving after parked.

- Sensor enters Parking Mode when stoped for over 15 minutes or parked and enters First Block Mode when acceleration of 4g(15~20km/h) is detected on Parking Mode.

Perform "Diagnostic Trouble Codes(DTC)" with GDS.

Fig.1) Diagnostic Trouble Code(DTC) is shown above

Erase DTC.

After erase DTC Check for any DTCs again.

Is the same DTC occurred again?

	▶ Go to Next procedure.
	▶ Fault is intermittent caused by poor contact in the TPMS module’s connector or was repaired and TPMS module memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.

Connect GDS to Data Link Connector(DLC).

IG "ON"

Monitor "Sensor Learn Progress","Sensor Learnd" parameter on "Current Data" with GDS.

Is parameter within specifications?

▶ Fault is intermittent caused by poor contact in the TPMS module’s connector or was repaired and TPMS module memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.

▶ Check for correct TPMS Sensor ID. ▶ In case sensor pressure is abnormal, compare tire pressure from pressure gauge and pressure information from Current Data with GDS. ▶ Substitute with known-good TPMS Sensor and check for proper operation. If problem is corrected, replace TPMS Sensor and then go to "Verification of Vehicle Repair" procedure. ▶ Perfrom "Register Sensor" in "Vehicle S/W Management" with GDS TPMS(Exciter) or drive vehicle with over 25 km/h for 10 minutes to complete auto-learning and auto-location, after TPMS Sensor is replaced.

note

Reference) Write VIN

1. Connect GDS to Data Link Connector(DLC).

2. Ignition "ON"

3. Select "Write VIN" in "Vehicle S/W Management" with GDS.

4. Perform following procedure.

FIG.1) Write VIN1

FIG.2) Write VIN2

FIG.3) Write VIN3

FIG.4) Write VIN4

Reference) Vehicle Name Writing

1. Connect GDS to Data Link Connector(DLC).

2. Ignition "ON"

3. Select "Vehicle Name Writing" in "Vehicle S/W Management" with GDS.

4. Perform following procedure.

FIG.1) Vehicle Name Writing 1

FIG.2) Vehicle Name Writing 2

FIG.3) Vehicle Name Writing 3

FIG.4) Vehicle Name Writing 4

Reference) Register Sensor

1. Connect GDS to Data Link Connector(DLC).

2. Ignition "ON"

3. Select "Register Sensor" in "Vehicle S/W Management" with GDS.

4. Perform following procedure.

FIG.1) Register Sensor 1

FIG.2) Register Sensor 2

FIG.3) Register Sensor 3

FIG.4) Register Sensor 4

FIG.5) Register Sensor 5

FIG.6) Register Sensor 6