4.
Monitor "Purge Control Valve" parameter in "Current Data" with GDS.
Specification : Refer to Figure below
Connect GDS to Data Link Connector(DLC).
Ignition "ON" & Engine "OFF".
Perform "Canister Purge Valve" in "Actuation Test" with GDS.
Monitor "Purge Control Valve" parameter in "Current Data" with GDS.
Specification : Refer to Figure below
Is the parameter displayed within specification?
 | ▶ Go to next procedure. |
 | ▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure. |
Connect GDS to Data Link Connector(DLC).
Ignition "ON" & Engine "OFF".
Perform "Canister Shut Off Valve(OBD-2 Only)" and "Canister Shut Off Valve Clocked(OBD-2 Only)" in "Actuation Test" with GDS.
Monitor "Canister Close Valve(Option)" parameter in "Current Data" with GDS.
Specification : Refer to Figure below
Is the parameter displayed within specification?
| ▶ Go to next procedure. |
| ▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure. |
Refer to "Shop Manual" and viasullay and/or physically inspect following conditions;
▶ Cracks or leakage on canister.
▶ Loose connection, distortion, or damage of the vapor hose/tube.
Has any problems been found?
Fig.1) A : Canister - Atmosphere / B : Canister - Fuel Tank / C : Canister - Intake Manifold
| ▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure. |
| ▶ Go to next procedure. |
Refer to "Shop Manual" and viasullay and/or physically inspect following conditions;
▶ Cracks or damages on Fuel Filler Cap.
▶ Proper installation of Fuel Filler Cap.
▶ Correct Type of Fuel Filler Cap.
Has any problems been found?
| ▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure. |
| ▶ Go to next procedure. |
Refer to "Shop Manual" and viasullay and/or physically inspect following conditions;
▶ Cracks or damages on Fuel Tank.
Has any problems been found?
| ▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure. |
| ▶ Carefully re-do this troubleshooting guide steps. ▶ Perform "Evap. Leakage Test" procedure and then, go to "Verification of Vehicle Repair" procedure. |
