The deviation of the camshaft position from the target point is evaluated during stable driving condition. The PCM accumulates this deviation for a certain period and sets DTC P0011 when the accumulated deviation is too high. The target camshaft position is predetermined value depending on engine speed and throttle angle in the PCM.
Item | Detecting Condition | Possible Cause | |
DTC Strategy | Case 1 |
•
Deviation check between actual CAM position and CAM setpoint position in case of changing setpoint (slow response of actuator) | 1. Poor Connector Connection 2. Contamination of Oil / Clogged Oil Line 3. Defected Oil Control Valve 4. Defected Cam Phaser 5. Defected Intake CVVT Assembly |
Case 2 |
•
Deviation check between actual CAM position and CAM setpoint position (steady deviation) | ||
Enable Condition | Case 1 |
•
2 sec. after engine start
•
Camshaft Set-point movement more than 12 ˚CRK within in less than 0.8 sec.
•
Camshaft set-point moved more than 5 times since engine start
•
Engine Speed at between 600 RPM and 1500 RPM or lower than 5000 RPM
•
Engine Oil Temp. higher than 68℉(20℃) and lower than 120℉(49℃)
•
Battery voltage higher than 10 V and lower than 16 V
•
No relevant DTC present | |
Case 2 |
•
2 sec. after engine start
•
Camshaft set-point moved more than 5 times since engine start
•
Camshaft set-point not close to full retard position (3 ˚CRK away from full retard position)
•
Camshaft set-point close to full retard position ( 13 to 23 engine revolutions passed after camshaft set-point changes, depending on RPM/Oil temp. model)
•
Camshaft set-point minus Actual position more than 5 ˚CRK
•
Engine Speed at between 600 RPM and 1500 RPM or lower than 5000 RPM
•
Engine Oil Temp. higher than 68℉(20℃) and lower than 120℉(49℃)
•
Battery voltage higher than 10 V and lower than 16 V
•
No relevant DTC present | ||
Threshold Value | Case 1 |
•
CAM position movement less than 3.4 °CRK within 0.8 sec. (with CAM setpoint moving by 12 °CRK) | |
Case 2 |
•
Integral of Camshaft position actual value - Camshaft position setpoint higher than 45°CRK*sec.
•
Integral of Camshaft position actual value - Camshaft position setpoint higher than 30°CRK*sec. when actual camshaft movement is slower than camshaft setpoint movement in retard direction. ※ For error detection, the above condition should be met 5 times. | ||
Diagnostic Time | Case 1 |
•
Immediate | |
Case 2 |
•
Immediate | ||
MIL ON Condition |
•
2 Driving Cycle | ||
