Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Has a problem been found?

	▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure.
	▶ Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "Verification of Vehicle Repair" procedure.

IG KEY 'OFF'.

Disconnect PCM and Fuel Level Sender 'A' harness connector.

Measure resistance between signal terminal of Fuel Level Sender 'A' harness connector and chassis ground.

Is resistance within specification?

	▶ Go to next procedure.
	▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure.