4.
Check the data chagnes by pressing ON/OFF switch of SPAS Active.
Fig.1) SPAS Active
Connect scantool to Data Link Connector (DLC).
Engine "ON".
Select the " SPAS Active" parameter among Current Data.
Check the data chagnes by pressing ON/OFF switch of SPAS Active.
Fig.1) SPAS Active
Is the parameter displayed within specifications?
 | ▶ Fault is intermittent caused by poor connection in SPAS Switch and SPAS ECU's connector or was repaired and SPAS ECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to "Termminal Connector Inspection" procedure. |
