8020324

1.

Ignition "OFF".

2.

Ignition "ON".

3.

Connect GDS to Data Link Connector(DLC).

4.

Monitor "Diagnostic Trouble Codes(DTC)" with GDS.

5.

Clear all DTCs in the system with GDS.

6.

Operate AVH Switch

7.

Check for AVH Operation Lamp is turned "ON" on Instrumental Cluster.

8.

Is AVH Operation Lamp turned "ON"?

▶ Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors(and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.

▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.

▶ Substitute with known-good AVH Switch and check for proper operation. If problem is corrected, replace AVH Switch and then go to "Verification of Vehicle Repair" procedure.