8020849

1.

IG "OFF".

2.

Connect GDS.

3.

IG "ON" and engine "OFF".

4.

Select "Diagnostic Trouble Codes(DTC)" mode.

5.

Check for any DTCs on the "Diagnostic Trouble Code(DTC)" with GDS.

6.

Erase DTC.

Fig.1) Diagnostic Trouble Code(DTC) is shown above

7.

After erase DTC Check for any DTCs again.

8.

Is the same DTC occurred again?

	▶ Go to Next procedure.
	▶ Fault is intermittent caused by poor contact in the TPMS module’s connector or was repaired and TPMS module memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.

9.

Connect GDS to Data Link Connector(DLC).

10.

IG "ON"

11.

Monitor each "Wheel Speed Sensor" parameters in ESP system "Current Data" with GDS.

Specification : Refer to Current Data while Driving the vehicle.

12.

Is parameter within specifications?

▶ Fault is intermittent caused by poor contact in the TPMS module’s connector or was repaired and TPMS module memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.

▶ Check for each Wheel Speed Sensor, repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.

▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.