8023485

Component Inspection

■ Check Driver Mode Actuator

Ignition "OFF"

Disconnect Driver Mode Actuator and connect A/C control module main harness connector.

Connect (+) terminal of battery to WARM(+) of Driver Mode Actuator and (-) terminal to COOL(-). (Component side)

Verify that the Driver Mode Actuator operates to the WARM position.

Verify that the Driver Mode Actuator operates to the COOL position with reverse connecting. ( COOL(+) and WARM(-) ). (Component side)

caution

Check for proper operation when BATT(12V) power is supplied and follow safety regulations.

Specification : Refer the specifications in Fig.1)

Fig.1)

Actuator harness	WARM(+)	COOL(-)	Door position
Battery terminal	12 V	ground	Max.warm
Battery terminal	ground	12 V	Max.cool

Fig.1) Function of the actuator motor according to terminal connection type. (observe safety regulations)

Is measured value within specification?

▶ Perform following procedures.

▶ Substitute with a known-good Driver Mode Actuator and check for proper operation.

▶ If the problem is corrected, replace Driver Mode Actuator and then go to "Verification of Vehicle Repair" procedure.

■ Check Driver Direction potentiometer(Mode Actuator)

Ignition "OFF"

Connect Driver Direction potentiometer(Mode Actuator) and A/C control module main harness connector.

Ignition "ON" , Engine "OFF"

10.

Measure voltage between Signal(F/B) terminal of Driver Direction potentiometer(Mode Actuator) harness connector and Sensor ground(-) terminal of A/C control module harness connector. (Component side)

Specification : Refer the specifications in Fig.2)

Fig.2)

Mode Door Position	Voltage
VENT	0.3±0.15V
BI-LEVEL	1.4±0.4V
FLOOR	2.5±0.4V
MIX	3.6±0.4V
DEF	4.7±0.15V

Fig.2) Voltage value of Driver Direction potentiometer(Mode Actuator) as a function of temp door position.

11.

Is measured value within specification?

	▶ Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
	▶ Substitute with a known-good Driver Direction potentiometer(Mode Actuator) and check for proper operation. If the problem is corrected, replace Driver Direction potentiometer(Mode Actuator) and then go to "Verification of Vehicle Repair" procedure.