3.
Disconnect the push rod from the clutch pedal by removing the snap pin (A) and washer (B).
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
Remove the following items;
Air cleaner assembly and air duct
(Refer to "Intake and Exhaust system" in EM group)
Battery
(Refer to "Charging system" in EE group)
Remove the brake fluid from the clutch master cylinder reservoir with a syringe.
Disconnect the push rod from the clutch pedal by removing the snap pin (A) and washer (B).
Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.
Remove the clutch master cylinder by turning it clockwise.
Install in the reverse order of removal.
Perform bleeding air procedure in clutch release cylinder after pouring the brake fluid.
(Refer to "Clutch release cylinder" in CH group)
