1.
Loosen the nuts (B) and then remove the cover (A).
Loosen the nuts (B) and then remove the cover (A).
Loosen the mounting bolts (A) and remove the regulator assembly (B).
Remove the slip ring guide (A).
Remove the OAD cap. (With OAD)
When installing, replace with new OAD cap.
Remove the pulley (A). (Without OAD)
Using the SST (09373-27000), remove the OAD pulley (A). (With OAD)
Loosen the 4 bolts (A) and then remove the rear housing (B).
Disconnect the rotor (A) and the housing (B).
Reassembly is the reverse order of disassembly.
