Turn ignition OFF and disconnect the negative (-) battery cable.

Remove the crash pad lower panel and reinforcing panel. (Refer to the Body group-crash pad)

Remove the junction box. (Refer to the Body Electrical System group - Fuses and Relays) [LHD only]

Disconnect the parking brake switch connector (A).

Remove the parking brake cable mounting nut (A).

[LHD]

[RHD]

Remove the parking brake pedal mounting bolts (A) and nuts (B).

[LHD]

[RHD]

Remove the parking brake cable adjusting nut (A) and the fixing clip (B), and then remove the parking brake pedal.

Remove the floor console. (Refer to the Body group - Console)

Remove the shift lever assembly. (Refer to the Automatic Transaxle group - shift lever)

Remove the paring brake cable (B) after removing the cable retainer (A).

Remove the parking brake cable fixing clip (A) and bolts (B). And then remove the front parking brake cable.

Raise the vehicle, and make sure it is securely supported.

Remove the parking brake cable (B) after removing the fixing clip (A).

Loosen the parking brake cable bracket bolts and remove the rear parking brake cable.

Remove the floor console. (Refer to the Body group - Console)

Disconnect the parking brake switch connector (A).

Remove the parking brake cable (B) after removing the cable retainer (A).

Remove the parking brake lever assembly after removing the bolts (A) as shown below.

Raise the vehicle and make sure it is securely supported.

Remove the rear wheel & tire.

Remove the parking brake cable (B) after removing the fixing clip (A).

Loosen the parking brake cable braket bolts and remove the parking brake cable.

Raise the vehicle, and make sure it is securely supported.

Remove the rear tire and wheel.

Remove the rear brake caliper and Rear disc brake.

(Refer to "Rear disc brake removal")

Remove the parking brake cable (B), after removing the fixing clip (A).

Loosen the hub assembly mounting bolts (A), and then remove the hub assembly and parking brake assembly.

Remove the adjuster assembly (B) and the lower return spring (A).

Remove the upper return spring (C) operating lever assembly (D).

Remove the shoe hold down pin (A) and the spring (B) by pressing and rotating the spring.

Remove the brake shoes (C).