Is measured value within specification?
 | ▶ Carefully re-do this troubleshooting guide steps. ▶ If the diagnostics have been performed correctly with no failure found, replace the PCM and then go to "Verification of Vehicle Repair" procedure. caution When replacing the PCM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the case of installing used PCM] 1) Perform "PCM Neutral mode" procedure with GDS. (Refer to "Immobilizer" in BE group) 2) After finishing "PCM Neutral mode", perform "Key teaching" procedure with GDS. (Refer to "Immobilizer" in BE group) [In the case of installing new PCM] Perform "Key teaching" procedure with GDS. (Refer to "Immobilizer" in BE group) caution When replacing the PCM, the vehicle equipped with the smart key system (Button start) must be performed procedure as below. [In the case of installing used PCM] 1) Perform "PCM Neutral mode" procedure with GDS. (Refer to "Smart key" in BE group) 2) After finishing "PCM Neutral mode", insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the PCM learns the smart key information automatically. [In the case of installing new PCM] Insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the PCM learns the smart key information automatically. |
 | ▶ Carefully re-do this troubleshooting guide steps. ▶ If no problems were found with the circuits or connectors, Replace the Injector and then go to "Verification of Vehicle Repair" procedure. caution
–
Install the component with the specified torques.
–
Note that internal damage may occur when the component is dropped or mis- treated. |
