7889977

1.

Ignition "OFF".

2.

Disconnect Battery (-) terminal.

3.

Refer to "Shop Manual" and disconnect Electric Waste Gate Actuator (EWGA) connector.

4.

Measure resistance between Pin No. 1 (Output +) terminal and Pin No. 3 (Output -) terminal of Electric Waste Gate Actuator (EWGA) component.

Specification : Approx. 1.44 ~ 1.96Ω at 21℃(69.8℉)

5.

Is measured value within specification?

▶ Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors ( and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.

▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.

▶ Carefully re-do this troubleshooting guide steps.

▶ If problem still occurs, replace Electric Waste Gate Actuator (EWGA) and then go to "Verification of Vehicle Repair" procedure.