Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check all connectors(and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.

Has a problem been found?

	▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure.
	▶ Go to "CAN Communication Circuit Inspection" procedure.

Ignition "OFF".

Disconnect Battery (-) terminal.

Disconnect EPB ECU and ECM/PCM connector.

Measure resistance between CAN High terminal of EPB ECU harness connector and CAN High terminal of TCU harness connector.

Measure resistance between CAN Low terminal of EPB ECU harness connector and CAN Low terminal of TCU harness connector.

Is measured value within specification?

	▶ Go to "Component Inspection" procedure.
	▶ Repair open in CAN Communication circuit between EPB ECU and TCU harness connector and then go to "Verification of vehicle Repair" procedure.