Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check all connectorss(and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.

Has a problem been found ?

	▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure.
	▶ Go to "CAN Communication Circuit Inspection" procedure.

Ignition "OFF".

Make sure all control modules' connectors are properly connected.

Ignition "ON".

Measure waveform signal between C-CAN High terminal of data link connector and chassis ground with Oscilloscope.

Measure waveform signal between C-CAN Low terminal of data link connector and chassis ground with Oscilloscope.

Is measured value within specification?

	▶ Go to "Component Inspection" procedure.
	▶ Check short to ground in CAN communication line. And then, go to 'Verification of Vehicle Repair" procedure. ▶ Check short to battery in CAN communication line. And then, go to 'Verification of Vehicle Repair" procedure.