Many malfunctions in the electrical system are caused by poor connection. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration,or damage.

Has a problem been found?

	▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure.
	▶ Perform following procedures.

Ignition "OFF"

Disconnect passenger air mix actuator and A/C control module main harness connector.

Measure resistance between WARM terminal of passenger air mix actuator harness connector and WARM terminal of A/C control module harness connector.

Measure resistance between COOL terminal of passenger air mix actuator harness connector and COOL terminal of A/C control module harness connector.

Is measured value within specification?

	▶ Perform following procedures.
	▶ Check for open in harness. ▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure.

Ignition "OFF"

Disconnect passenger air mix actuator and A/C control module main harness connector.

Measure resistance between WARM terminal of passenger air mix actuator harness connector and chassis ground.

Measure resistance between COOL terminal of passenger air mix actuator harness connector and chassis ground.

Is measured value within specification.

	▶ Go to "Component inspection" procedure.
	▶ Check for short to ground in control harness. ▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure.