5.
Test Condition : A/C "OFF" and A/C "ON".
Specification : Refer to Figure below
Fig.1) A/C Pressure Increase as A/C is turned "ON"
Ignition "OFF".
Connect GDS to Data Link Connector(DLC).
Ignition "ON".
Monitor "A/C Pressure" and "A/C Pressure Voltage" parameter in "Current Data" with GDS.
Test Condition : A/C "OFF" and A/C "ON".
Specification : Refer to Figure below
Fig.1) A/C Pressure Increase as A/C is turned "ON"
Is the parameter dispalyed within specification?
 | ▶ Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors ( and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage. ▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
 | ▶ Carefully re-do this troubleshooting guide steps. ▶ If no problems were found with the circuits or connectors, Replace the A/C Pressure Transducer and then go to "Verification of Vehicle Repair" procedure. |
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped or mis- treated.
