7955726

1.

Connect GDS to Data Link Connector(DLC).

2.

Ignition "ON".

3.

Monitor "Diagnostic Trouble Codes(DTC)" with GDS.

4.

Is DTC status displayed as Present?

	▶ Go to "Current Data Inspection" procedure.
	▶ Go to "Verification of Vehicle Repair" procedure.

5.

Connect GDS to Data Link Connector(DLC).

6.

Engine "ON".

7.

Monitor "Wheel Speed" parameters in "Current Data" with GDS.

8.

Compare each wheel speed sensor parameters while driving vehicle and check displayed values are similar to each other.

9.

Is displayed parameters similar to each other?

▶ Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors(and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.

▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.

▶ Go to "Wiring Inspection" procedure.