7956986

1.

Ignition "ON".

2.

Back probe and measure voltage between signal terminal and ground terminal of clutch switch harness connector.

3.

Operate Clutch Switch.

Specification : On Clutch pedal not pressed : Approx. 12V / On Clutch pedal pressed : Approx. 0V

4.

Is measured value within specification?

	▶ Substitute with known-good HECU and check for proper operation. If problem is corrected, replace HECU and then go to "Verification of Vehicle Repair" procedure. caution n case of replacing HECU, perform following procedures. 1. "ASP Calibration" for steering angle sensor offset correction. 2. "Longitudinal G-Sensor Calibration" for longitudinal sensor offset correction. 3. "Variant Coding".
	▶ Substitute with known-good Clutch switch and check for proper operation. If problem is corrected, replace Clutch switch and then go to "Verification of Vehicle Repair" procedure.