3.
Has a problem been found?
 | ▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to next procedure. |
Many malfunctions in the electrical system are caused by poor harness and terminals.
Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
Thoroughly check all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
Has a problem been found?
| ▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure. |
| ▶ Go to next procedure. |
IG Key "OFF".
Disconnect Passenger Power Outside Mirror connector and BSD ECU(LH) connector.
Measure the resistance between DRV LED (+) terminal of Passenger Power Outside Mirror harness connector and DRV LED (+) of BSD ECU(LH) harness connector.
Measure the resistance between DRV LED (-) terminal of Passenger Power Outside Mirror harness connector and DRV LED (-) of BSD ECU(LH) harness connector.
Specification : below 1Ω
Is the measured resisance normal?
| ▶ Go to next procedure. |
| ▶ Check open in Passenger Power Outside Mirror signal circuit. And then, go to "Verification of Vehicle Repair" procedure. |
IG Key "OFF".
Disconnect mirror connector of the RH outside mirror.
Check the resistance between the RH outside mirror signal circuit and power circuit.
Specification : ∞ Ω
Is the measured resisance normal?
| ▶ Substitute with known-good BSD ECU and then check for proper operation. If problem is corrected, replace BSD ECU and then go to "Verification of Vehicle Repair" procedure. |
| ▶ Check short to ground in Passenger Power Outside Mirror signal Circuit. And then, go to "Verification of Vehicle Repair" procedure. |
