8000558

Monitor DTC Status

Connect GDS to Data Link Connector(DLC).

Ignition "ON".

Monitor "Diagnostic Trouble Codes(DTC)" with GDS.

Is DTC status displayed as Present?

	▶ Go to "Monitor GDS Data" procedure.
	▶ Go to "Verification of Vehicle Repair" procedure.

Monitor GDS Data

Ignition "OFF".

Connect GDS to Data Link Connector(DLC).

Ignition "ON" & Engine "ON".

Operate vehicle according to enable condition of Evap. Leakage Test.

Perform "Evap. Leakage Test" in "Vehicle S/W Management" with GDS.

note

Evap. Leakage Test Condition:1.

1. Vehicle Stopeed

2.Fuel Level Below 80%

3. No Trouble Code

4. Engine Idle State

5. Engine Coolant Temperature Above 176℉(80℃)

Fig.1) Test Screen 1

Fig.2) Test Screen 2

Fig.3) Test Screen 3

Fig.4) Test Screen 4

Has the test been successfully completed?

▶ Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors ( and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.

▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.

▶ Go to "System Inspection" procedure.