4.
Monitoring for (pending) DTC.Is the same DTC set?
 | ▶ Go to the applicable troubleshooting procedure. |
 | ▶ System performing to specification at this time. |
Start engine to normal operating temperature
Evaporative Emissions Systems (EVAP) Leak Tests can be run by the GDS. The tests are automated and provide either a pass-fail result or directions to check for DTCs.
Install GDS and clear DTC
Perform "EVAP. LEAKAGE TEST" mode referring to enable conditions as below
EVAP. Leakage Test enable conditions
- Following conditions must be fulfilled to start the test.
1) Engine warm up at Idle Status
2) No relevant DTC
3) Fuel level is below 80%
Monitoring for (pending) DTC.Is the same DTC set?
| ▶ Go to the applicable troubleshooting procedure. |
| ▶ System performing to specification at this time. |
