Replacement
Front Seat Belt Replacement
caution

When installing the belt, make sure not to damage the pretensioner.

1.

Remove the following items first :

A.

Front seat assembly

(Refer to the BD group - "Front Seat")

B.

Front door scuff trim & rear door scuff trim

(Refer to the BD group - "Interior Trim")

2.

Remove the seat belt lower anchor cover (A).

3.

After loosening the mounting bolt, then remove the seat belt lower anchor (B).

Tightening torque:

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

4.

Remove the center pillar lower trim (A).

5.

After loosening the mounting screws, then remove the center pillar upper trim (A) .

6.

After loosening the mounting bolt, then remove the front seat belt upper anchor (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

7.

After disconnecting the pretensioner connector lock pin, remove the SIS connector (A), loosen the mounting bolts, then remove the pretensioner (B).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

8.

Installation is the reverse of removal.

Height Adjust Replacement
1.

Remove the following items first :

A.

Front seat assembly

(Refer to the BD group - "Front Seat")

B.

Front door scuff trim & Rear door scuff tirm

(Refer to the BD group - "Interior Trim")

C.

Front seat belt lower anchor

D.

Center pillar lower trim

(Refer to the BD group - "Interior Trim")

E.

Center pillar upper trim

(Refer to the BD group - "Interior Trim")

F.

Front seat belt upper anchor

2.

After loosening the bolts, then remove the height adjustor (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5kgf.m, 28.9 ~ 39.8 lb-ft)

3.

Installation is the reverse of removal.

note

Replace any damaged clips.

Make sure the height adjusts properly.

Front Seat Belt Buckle Replacement
1.

Remove the front seat assembly.

(Refer to the BD group - "Front Seat")

2.

After loosening the mounting bolt, then remove the front seat belt buckle (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

3.

Disconnect the connector mounting clip (A).

4.

Installation is the reverse of removal.

Яндекс.Метрика