1.
Install the CVVL assembly (A).
caution
Be careful not to interfere with front cam cap by positioning the 1st control shaft bearing toward the front of the engine as far as possible.
Install the CVVL assembly (A).
Be careful not to interfere with front cam cap by positioning the 1st control shaft bearing toward the front of the engine as far as possible.
Install the bearing caps.
Preassemble the No.1~4 bearing caps and CVVL shaft bearing caps temporarily.
Remove the SST (09221-3L000).
Preassemble the No.5 bearing cap temporarily.
Tighten the bolts, in several passes, in the sequence as shown.
Tightening torque
M6 bolts:
11.8 ~ 13.7 N.m (1.2 ~ 1.4 kgf.m, 8.7 ~ 10.1 lb-ft)
M8 bolts:
18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)
Be careful not to change the position and direction of bearing caps.
Install the CVVL motor (A). (Refer to FL group)
Install the CVVL position magnet wheel (A). (Refer to FL group)
Tightening torque :
9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
Install the CVVL position sensor (A). (Refer to FL group)
Tightening torque :
9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
Install the cylinder head cover. (Refer to Timing System in this group)
