3.
Disconnect the BSD connector (A) from the BSD unit.
Disconnect the negative (-) battery.
Be careful when removing the blind spot detection unit. The bracket may break off from the bumper.
Remove the rear bumper.
(Refer to Body - "Rear Bumper Cover")
Disconnect the BSD connector (A) from the BSD unit.
Remove the BSD assembly (A) after loosening the mounting screws and fasteners.
Remove the BSD unit (A) after loosening the mounting screws.
When removing the BSD unit, separate the fixed clip from the connector.
Ready the radar sensor RH and LH for each side properly.
Install the radar sensor to the bracket correctly (distinguish RH & LH) with mounting nuts.
The shape of the left and right blind spot detection unit is different. Therefore, take notice when installing the blind spot detection unit.
Radar Sensors must be closed up against the bracket completely.
After mounting radar sensors, check a wobble.
Connecto the negative (-) battery terminal.
Left side (Slave) | Right side (Master) | |
Shape |  |  |
Remark | The location of the bracket is different. | |
When replacing the BSD unit , you have to input the detailed regional information into the BSD unit. This learning process is called variant coding.
Follow the procedures which describes on the GDS screen.
