3.
Remove the crash pad side switch assembly (A) as shown below picture.
caution
Wear globes to protect hands from injury.
Disconnect the negative (-) battery terminal.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
Remove the crash pad side switch assembly (A) as shown below picture.
Wear globes to protect hands from injury.
Remove the crash pad lower switch assembly (B) after disconnecting the connector (A).
Install the blind spot detection switch after connecting the connector.
Install the crash pad lower panel.
Disconnect the BSD switch connector from the crash pad lower switch assembly.
Operate the BSD switch, then check for continuity between terminals BSD switch connector.
