3.
Separate the speed sensor cable from connector bracket (D) after disconnect the speed sensor connector (C).
Remove the following items;
Engine cover.
Air cleaner assembly and air duct.
(Refer to "Engine And Transaxle Assembly" in EM group)
Battery and battery tray.
(Refer to "Charging system" in EE group)
Disconnect the back up lamp switch connector (A) and neutral position switch (B).
Separate the speed sensor cable from connector bracket (D) after disconnect the speed sensor connector (C).
Disconnect the cable assembly (A) from transaxle.
Remove the washer and pin (B).
Remove the bracket mounting bolts (C).
Tightening torque:
14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m,10.9 ~15.9 lb-ft)
Remove the ground cable (A) from transaxle.
Remove the CKP sensor (A) by removing a bolt.
Disconnect the concentric slave cylinder tube (A) after removing the pins (B).
Remove the transaxle upper mounting bolts (B-2ea) and the start motor mounting bolts (A-2ea).
Tightening torque
(A): 49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
(B): 78.5 ~ 98.1 N.m (8.0 ~ 10.0 kgf.m, 57.8 ~ 72.3 lb-ft)
Using the SST (09200-38001), hold the engine and transaxle assembly safely.
Remove the cover (A).
Remove the automatic transaxle mounting support bracket bolt (A).
Tightening torque:
107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)
Remove the transaxle support bracket bolts (A).
Tightening torque:
58.9 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.9 lb-ft)
Remove the under cover (A).
Remove the following items;
Drive shaft assembly.
(Refer to "Drive shaft assembly" in DS group.)
Sub frame assembly.
(Refer to "Front suspension system" in SS group)
Remove the drive shaft cover mounting bolt (A).
Loosen the turbo charger hose by loosening a clamp and removing the bolts (A-2ea).
Remove the dust cover by removing the bolts (A).
Tightening torque:
35.0 ~ 50.0 N.m (3.5 ~ 5.0 kgf.m, 25.3 ~ 36.2 lb-ft)
Remove the lower mounting bolts (A-2ea, B-2ea) of lower part of the transaxle, and remove the transaxle assembly by supporting it with a jack.
Tightening torque:
(A) 42.2 ~ 54.0 N.m (4.3 ~ 5.5 kgf.m, 31.1 ~ 39.8 lb-ft)
(B) 35.0 ~ 50.0 N.m (3.5 ~ 5.0 kgf.m, 25.3 ~ 36.2 lb-ft)
Installation is the reverse of removal.
Adding Manual transaxle fluid.
(Refer to "Manual transaxle system" in this group.)
Perform bleeding air procedure in concentric slave cylinder after pouring the brake fluid.
(Refer to "Concentric slave cylinder" in CH group.)
If the oil seal on the transaxle case side is damaged and fluid is leaking, replace the oil seal with a new unit. When installing the new oil seal, use the specialized tool (09453-3B400).
