Turn ignition switch OFF.

Disconnect the oil temperature sensor connector.

Measure resistance between sensor signal terminal and sensor ground terminal.

Check that the resistance is within the specification.

Change the shift lever to "N" range.

Remove the valve body assembly.

(Refer to Hydraulic System - "Valve Body")

Disconnect the input & output speed sensor connector (A).

Loosen the main connctor bolt (B).

Dissconnect the solenoid valve connector (A).

Remove the solenoid valve connector clip (B) after loosening a bolt.

Install in the reverse order of removal.

note

●

Adding Automatic Transaxle Fluid(ATF).

(Refer to Hydraulic System - "Fluid")

●

Perform Transaxle Control Module(TCM) learning after replacing the valve body to prevent slow transaxle response, jerky acceleration and jerky startup.

(Refer to Automatic Transaxle Control System - "Repair procedures")

●

Use new valve body gasket (A).