1.
Remove the under cover (A).
Remove the under cover (A).
Remove the drain plug (A) and reinstall the drain plug after draining ATF totally.
Tightening torque :
38.2 ~ 48.1 N.m (3.9 ~ 4.9 kgf.m, 28.2 ~ 35.4 lb-ft)
Replace the gasket before reinstalling the drain plug.
Air cleaner assembly and air duct.
(Refer to "Intake and Exhaust system" in EM group.)
Battery and battery tray.
(Refer to "Charging system" in EE group.)
Remove the wiring bracket (A).
Remove the air breather hose (A).
Remove the valve body cover (B).
Tightening torque:
13.7 ~ 15.7 N.m (1.4 ~ 1.6 kgf.m, 10.1 ~ 11.6 lb-ft)
Remove the solenoid valve (B) connector and the oil temperature sensor (A).
Remove the valve body assembly (A).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Install in the reverse order of removal.
Adding Automatic Transaxle Fluid(ATF).
(Refer to Hydraulic System - "Fluid")
Perform Transaxle Control Module(TCM) learning after replacing the valve body to prevent slow transaxle response, jerky acceleration and jerky startup.
(Refer to Automatic Transaxle Control System - "Repair procedures")
Use new valve body gasket (A).
