5.
Disconnect the inhibitor switch connector (A).
Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
Remove the air cleaner assembly.
(Refer to "Intake manifold" in EM group.)
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
Remove the shift cable mounting nut (B).
Tightening torque:
9.8 ~ 13.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.1 lb-ft)
Disconnect the inhibitor switch connector (A).
Remove the manual control lever (B) and the washer after removing a nut (A).
When installing, affix the manual control lever and the inhibitor switch with Ø5mm (0.1969in.). Then tighten the inhibitor assembly mounting bolts.
Remove the inhibitor assembly (A) after removing the bolts (2ea).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
When installing, tighten the inhibitor assembly mounting bolt lightly, so that necessary adjustments can be made. Tighten to specifications.
Install in the reverse order of removal.
Use a SST (09480-A3800) or 0.1969in.( 5mm) bolt fix the inhibitor manual control lever in the N jig hole (A) when you assemble the inhibitor (B).
Adjust the shift cable after you install the inhibitor switch.
(Refer to Automatic Transaxle Control System - "Shift lever")
