13455014

Disconnect the battery terminals. (Refer to Engine and transaxle assembly in this group)

Remove the air duct and the air cleaner assembly. (Refer to Engine and transaxle assembly in this group)

Remove the battery. (Refer to Engine and transaxle assembly in this group)

Remove the front bumper. (Refer to BD group)

Disconnect the boost pressure sensor connector (A).

Disconnect the intercooler inlet hose (B) and the outlet hose (C).

Tightening terque :

4.9 ~ 6.9N.m (0.5 ~ 0.7kgf.m, 5.1 ~ 6.6 lb-ft)

caution

It is allowed to plaster cleaning liquid or alcohol on the connecting surfaces of hose and pipe, but all kinds of oil is prohibited.

note

●

The clip wing must be located on the position mark of hose and must not run over it.

●

The paint marking of hose must be in line with the protrusion of the intercooler.

●

The groove of hose must be in line with the stopper of the pipe or throttle body.

●

The band must be located on the position mark of hose and must not run over it.

●

Tighten the torque control cap until it separated. If a torque control cap has already removed, tighten the screw at the specified torque.

Remove the intercooler mounting bracket (A) and then remove the intercooler assembly.

Tightening torque :

6.9 ~ 10.8N.m (0.7 ~ 1.1kgf.m, 5.1 ~ 8.0lb-ft)

Installation is the reverse order of removal.