1.
Remove the air cleaner assembly (A). [Except RHD]
Remove the air cleaner assembly (A). [Except RHD]
Disconnect the brake fluid level switch connector (B) from the reservoir.
LHD
RHD
Remove the brake fluid from the master cylinder reservoir with a syringe.
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
Disconnect the brake tube (C) from the master cylinder by loosening the tube flare nut.
Tightening torque:
ABS : 12.7 ~ 16.7N.m (1.3 ~ 1.7kgf.m, 9.4 ~ 12.3lb-ft)
ESP : 18.6 ~ 22.6N.m (1.9 ~ 2.3kgf.m, 13.7 ~ 16.6lb-ft)
LHD
RHD
Remove the master cylinder (B) from the brake booster after loosening the mounting nuts (C).
Tightening torque:
12.7 ~16.7N.m (1.3 ~1.7kgf.m, 9.4 ~12.3lb-ft)
LHD
RHD
Installation is the reverse of removal.
After installation, bleed the brake system. (Refer to Brake system bleeding)
