Disconnect the negative (-) battery terminal.

Remove the center fascia panel (A).

(Refer to BD group - "Crash pad")

Remove the audio assembly (A) after loosening the mounting screws.

(Refer to BD group - "Crash pad")

After disconnecting the smart key unit connector, loosen the smart key unit mounting bolt and nut, and remove the smart key unit (A).

Disconnect the negative (-) battery terminal.

Remove the floor console upper cover (A).

(Refer to BD group - "Console")

Remove the audio assembly (A).

(Refer to BD group - "Crach pad")

After loosening the mounting nut (1EA), disconnect the connector and remove the receiver (A).

Disconnect the negative (-) battery terminal.

Remove the console assembly (A).

(Refer to BD group - "Console")

After loosening the antenna bolts (2EA) and connector, remove the interior 1 antenna (A).

Disconnect the negative (-) battery terminal.

Remove the console assembly (A).

(Refer to BD group - "Console")

After loosening the antenna nuts (2EA) and connector, remove the interior 2 antenna (A).

Disconnect the negative (-) battery terminal.

After loosening the mounting bolts, then remove the third seat assembly (A).

(Refer to BD group - "Rear seat")

After loosening the antenna nuts (2EA) and connector (A), remove the interior 3 antenna (B).

Disconnect the negative (-) battery terminal.

Remove the rear bumper.

(Refer to BD group - "Rear bumper")

Disconnect the antenna connector (A) on the center of rear bumper.

After loosening the nuts (2EA), remove the exterior bumper antenna (A).

Disconnect the negative (-) battery terminal.

Remove the front left wheel guide.

Disconnect the connectors, then remove the buzzer (A).

Disconnect the negative (-) battery terminal.

Disconnect the connector after removing the door trim.

(Refer to BD group - "Front door")

After loosening the mounting bolt, then remove the key holder (A).

Remove the outside handle (A) by sliding it rearward.

Disconnect the negative (-) battery terminal.

Remove the tailgate trim.

(Refer to BD group - "Tailgate trim")

Disconnect the connector. After loosening the remove tailgate garnish mounting nuts (6EA), then tailgate garnish (A).

Remove the outside handle (A) after loosening the outside handle mounting screws.