2.
After loosening the seat assembly mounting bolts, remove the seat assembly (A).
Tightening torque :
44.1 ~ 58.8N.m (4.5 ~ 6.0Kgf.m, 32.5~43.4lb-ft)
Remove the seat assembly mounting cover.
After loosening the seat assembly mounting bolts, remove the seat assembly (A).
Tightening torque :
44.1 ~ 58.8N.m (4.5 ~ 6.0Kgf.m, 32.5~43.4lb-ft)
Disconnect the power seat connector (A), airbag connector (B), seat belt buckle connector (C).
Installation is the reverse of removal.
SEAT MOUNTING BOLT INSTALLATION PROCEDURE
Set the into the most rearward position. Check then each slide is locked, and then Tighten the front mounting bolt temporarily.
Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.
Set the seat into the most rearward position. Check the front mounting bolt completely.
Check that the seat operates to and fro smoothy and the locking portion locks properly.
Remove the recliner switch (A) and height switch (B).
Loosen the seat recliner mounting screw.
When prying with a flat-up screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Using the screw driver or remover.
Push the hook (B) and then remove the recliner cover (A).
Push the lock pin, disconnect the connector (A).
Installation is the reverse of removal.
Replace the seat back assembly if active head rest system is equipped.
Remove front seat assembly.
Remove the recliner cover.
Disconnect the air back wire-ring (A).
Disconnect the protector (B).
Disconnect the clips (B) from the back frame cover (A).
Push the middle area of clip using the flat head screwdriver.
Be careful not to damage the clip.
Disconnect the clip (B), from the back frame and then remove the cover (A).
Disconnect the connector and then wirering (A).
Remove the air back mounting clip (B).
After loosening the mounting bolt, then remove the seat cushion assembly and seat back assembly.
Installation is the reverse of removal.
Remove front seat back assembly.
After removing the hogring clips (B) on the front of seat cushion and remove the seat cushion cover (A).
Remove the climate control seat mat (A) on the front of seat.
Installation is the reverse of removal.
Remove front seat assembly.
Remove the recliner cover.
After push the hook (B), remove the climate control seat duct (A).
After disconnect the protector (A), remove the seat cushion (C).
Disconnect the heated seat connector (A).
After removing the hog-ring clip (B) on the front of seat cushion and remove the seat cushion cover (A).
When removing the hog-ring clip, remove the hog-ring clip with pressing the wire not to separate the wire from the sponge.
Remove the climate control seat mat (A).
Installation is the reverse of removal.
Be careful not to damage the seat warmer line, when installing the hogring clips.
To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hogring clips (A).
Replace the hogring clips with new ones using special tool (C).
